Oil and gas operators must immediately suspend previously approved water diversions under Section 10 of the Water Sustainability Act, in some rivers within the Peace and Liard River watersheds.
DATE ISSUED: May 25, 2023
EFFECTIVE DATE: Immediately
The BC Energy Regulator (BCER) is requiring oil and gas operators to immediately suspend previously approved water diversions under Section 10 of the Water Sustainability Act, due to low flows. This includes rivers, streams and lakes in the following basins within the Peace River and Liard River watersheds:
Peace River Watershed:
- Beatton River (Doig River, Osborn River, Blueberry River)
- Kiskatinaw River
Liard River Watershed:
- Fontas River
Typically, suspension orders are issued by the BCER later in the summer and into early fall; however, this year drought conditions and streamflow response to drought is occurring much earlier than in previous years. While recent rain in the northeast is welcome, it has not been enough to alleviate concerns of low flows in the above listed river systems. Diversion and use of water stored in dugouts or dams is not suspended. Basins in other regions of B.C. are being monitored and further suspensions of water diversions are possible if conditions persist.
Given local variability, it is possible some streams in the areas under suspension will have recovered sufficiently to allow some water withdrawal. The BCER will review new applications for diversion, or requests to use existing approvals, on a site-specific basis.
Permit holders can discuss the suspension with the BCER and submit a request for continued water use under an existing Section 10 approval, by providing location-specific data and subject matter expert opinion relevant to local streamflow conditions.
Operators are requested to do the following to support their application or request to use an existing Section 10 approval:
- Limit the application to water volumes and points of diversion that are realistic to the specific operational needs for the upcoming months.
- For new applications for diversion for water from rivers and streams, or to request use of existing approvals, provide a good discharge measurement at the point(s) of diversion, to provide information on current flow conditions in relation to the volume of water requested. The discharge measurement will be collected to an acceptable hydrometric standard by a qualified individual.
- For new applications for diversion from lakes, or reactivation of existing approvals, provide information on lake bathymetry:
- Surface area (hectares).
- Depth (metres). If lake depth information is not already available from provincial databases or previous surveys, obtain depth measurements at points along two transects representing the long and short lake axes, to determine maximum lake depth.
- Volume.
More information:
- B.C. Government Drought Information page and Drought Information portal
- Check out our new data narrative for information on water use by industry
If you have any questions regarding this Directive, please contact:
Ryan Rolick, M.Sc., P.Geo.
Hydrologist
BC Energy Regulator
250-794-5213
Laurie Welch, Ph.D., P.Geo.
Executive Director, Responsible Stewardship
BC Energy Regulator
250-980-6066